Pop & Lock PL1700C - Manual

Installation Instructions
Tailgate Lock PL1700, PL1700C
Chevrolet Colorado 2004 - Up
GMC Canyon
PATENT PENDING
3
Remove the two 6 mm bolts from inside of the
tailgate to free the handle assembly.
6
Using the supplied key, test the lock by
locking and unlocking the tailgate.
4
Lift the tailgate into the up position but do not
fully engage in the latches. While supporting the
tailgate with one hand, pull the bottom of the
handle out first (a), then carefully pull out the
handle assembly from the top (b).
Contents:
Lock Assembly, 2 keys, Instructions, Warranty Card.
Technical Support:
Call 1-800-342-5911
[email protected]
Tools Required:
Philips screwdriver, Ratchet,
10 mm Socket, Ratchet extension.
2
Carefully detach the two latch rods from the
plastic clips and move aside.
1
Open the tailgate and if applicable, remove the
tailgate bed-liner. Using a philips screwdriver,
remove the screws holding the access panel.
Remove the access panel and set aside.
b
a
5
Install the Pop & Lock assembly into the
tailgate following Steps 2, 3 & 4 in reverse order
while making sure that it is in the lock position as
seen in picture below. Make sure that the
bottom small tabs snap onto the tailgate before
tightening the 6 mm bolts.
Small tabs
7
Re-install the access panel and bed-liner if
applicable.
For the latest instructions please visit www.popandlock.net
12-27-11