Monoprice PID 9205 Plug Play Wireless Day and Night Network IP Camera with Audio MPEG4 - Manual (Page 19)

Plug & Play Wireless Day and Night NetworkCamera
19
3.4. WiFi Security (for IP cam
(
w
)
only)
You can connect the IP CAM to the network wirelessly, provided you have a
wireless router or AP. Simply click the "Enable WiFi function” button to enable the
wireless functionality.
Figure 3-7: WiFi security disabled page
In order to use the wireless network, you need to fill in the following fields:
1. SSID – this is the ID of the wireless router or AP in your wireless network
environment.
2. Security mode – this is the security mode used by the wireless router or AP. You
need to choose one of the three modes – None, WEP, or WPA-PSK:
WEP: Wireless Encryption Protocol.
WPA: WiFi Protected Access.
PSK: Pre-Shared Key.
TKIP: Temporal Key Integrity Protocol.
AES: Advanced Encryption Standard.
3. WEP mode – when the WEP mode is chosen, you need to also choose between
the 64-bit (5 char), 64-bit (10 hex), 128-bit (13 char), and 128-bit (26 hex)
encryption modes, and then fill in the WEP key correctly.
4. WPA-PSK mode - when the WPA-PSK mode is chosen, you need to also choose
between the TKIP and AES encryption modes, and then fill in the WPA-PSK key
correctly. WPA2-PSK is also supported, but WPA/ WPA2 Enterprise is not.