Monoprice PID 9205 Plug Play Wireless Day and Night Network IP Camera with Audio MPEG4 - Manual (Page 17)

Plug & Play Wireless Day and Night NetworkCamera
17
3.3. Network
The Network page allows you to modify the network settings of the wired Ethernet
connection. The default settings use DHCP to obtain an IP address automatically. In
most home and office network environments, there is a DHCP server running. In this
situation, by using these default settings, the IP CAM can work immediately.
If the Ethernet cable is unplugged, the IP CAM will lose connection. But as soon
as the Ethernet cable is plugged in again, the IP CAM will obtain a new IP address
immediately.
If the network environment does not support the DHCP function you will need to
configure the network settings of the IP CAM manually. Fill in all the fields including
"IP address”, "Subnet mask”, "Default gateway”, and "DNS server”, to establish a
network connection. All these settings must be correct for your network environment
or the IP CAM will not work. The default setting is "Obtain an IP address
automatically”.
Figure 3-5: Network settings page for DHCP function