Monoprice 9207 IP Camera Converter - Manual (Page 9)

MPEG-4 Video Server
Second, Connect the video server product to the home/office network
Please connect the video server product to the home network or office network
through an Ethernet cable. Usually, this Ethernet cable is plugged into a home
NAT/router device or an Ethernet switch if in the office, as shown in Figure 2-2. Since
the default settings of the video server product use DHCP function and very often
there is a DHCP server on most of the Home/office network, the video server product
should be connected to the Internet immediately. The Internet status LED is constant
red light to indicate this good connection status. If the LED is blinking, please refer to
section 3.3~3.4 to try other network settings.
Figure 2-2: Connect architecture of the video server product.
Third, Install the CamView software on the notebook/PC
Please insert the installation CD into the CD-ROM drive in your notebook or
personal computer (must be running Microsoft Windows OS). Execute the program
CamViewInstaller-xxx.exe on the disk. The program will pop-up some windows about
the installation options, please press the “next” button to proceed with the installation.
After the installation is complete, there will be a CamView icon on the desktop of your
computer screen, please execute this icon. The CamView program will run
immediately.
9