Monoprice 9207 IP Camera Converter - Manual (Page 23)

MPEG-4 Video Server
3.8. Email/ftp Alarm
The video server product provides the Email/ftp function, you can enable or
schedule the Email/ftp ability in this page, the video server product will then send out
an email with a jpeg picture attached in the email and/or send out the jpeg picture file
to a ftp server. The related settings are explained below:
1. Email/FTP trigger – choose between “motion”, “D/I”, “schedule” and “disable”
A. If “motion” is selected, it means that when there is a motion detected, the
system will send out the email and/or ftp with the captured video snapshot.
B. If “D/I” is selected, it means that when there is a Digital input alarm detected,
the system will send out the email and/or ftp with the captured video
snapshot. If the D/I alarm is constantly on, the Video server will keep
sending out email/ftp message every second for up to 30 seconds.
C. If “schedule” is selected, it means that the email/ftp alarm detection and
triggering will be scheduled by the “scheduling” in section 3.11.
D. “disable” will disable the email/ftp alarm.
2. Motion sensitivity – there are three possible choices in this field.
“High” means high sensitivity, i.e., the detection is triggered by a very small
movement in the video image. If “High” is selected and the size of the moving
object is larger than about 1% of the whole video area, it is detected. Please be
noticed that the real size of the object could be large or small, anyway, the
detection is only based on the relative size of the object. Probably a small pencil
moving near the video server product could be detected, but a moving car far
away from the video server product could not be detected.
“Low” means low sensitivity, i.e., the detection is triggered by a very large
movement. If the size of the moving object is larger than about 10% of the whole
video area, it is detected. “Median” means 3% to trigger the detection.
3. Send email message – if this item is enabled, the video server product will send
out an email message with the jpeg picture attached to the specified email
account.
4. Email recipient – this is the email address to receive the detection notice message.
An email message with the jpeg picture file named by the date/time of the
triggered moment will reach this address.
5. SMTP server – this is the SMTP server that will help to transfer the email message.
This server is irrelevant to the “Email recipient” address.
6. SMTP username/password – this the account to use the SMTP server to transfer
the email message. The SMTP server and username/password account are only
for transfer the email message to the “Email recipient”, the “Email recipient” could
23