GReddy TURBO KITS: Honda Civic Si 2002-05 / T517Z - Manual (Page 21)

3-15 Starting the Engine
(1) Refill the engine oil to factory spec.
(2) Check all the hoses and wires
ne then nect egative e of
the battery.
(3) Tun the ignition to “ON” positio
3 get
injectors and the fuel rail for any fuel leaks.
* Repair any fuel leaks before starting the engine. Starting the engine with a
fuel leak can cause fire in the engin nt and can be
dangerous.
(4) Remove the ECM fuse and cra
e to oil pre
(Until the oil light on the dash turns off) Check for any oil leaks, then reinstall the
fuse and start the engine.
(5) While idling, check for any oil, coolant, or air leeks.
(6) After inspection, reinstall the under cover and other stock parts that was
remove
) e turbo-actuator
setting. This turbo kit is preset to boost between 0.6kg/cm 2 to 0.5kg/cm 2 .
This completes the Turbo Kit installation.
Important!
• It is very important that you monitor the boost pressure, and make sure
not to over boost. Over boosting can cause engine damage.
• GReddy Performance Products, Inc. is not responsible for any engine
damage caused by over boosting (increased boost), modification to the
kit, and/or misuse of the product. NO WARRANTY is offered.
• Due to lack of control over proper installation and use of this product,
his kit.
con ction, recon the n sid
n 2- times to fuel pressure. Then, check the
e compartme very
nk the engin get ssure to the turbo.
d.
(7 On the initial run, be sure to have a boost gauge to check th
It is very important that you monitor the boost pressure, and make sure not to
over boost. Over boosting can cause engine damage.
NO WARRANTY is offered for t