GReddy TURBO KITS: Honda Civic Si 2002-05 / T517Z - Manual (Page 18)

3-13 e-Manage
Installation
(1) Remove the cover under the glove box to access the ECU and ECU harness.
(2) Install the Grey wire to the e-Manage I/J Harness (18Pin) connector as shown
below.
(3) Connect the I/J Harness to the factory ECU harness as shown in the diagram on
next page.
(Parts used #15, 16, 17)
Important
• This installation should only be performed by a trained specialist who is very
familiar with the automobile’s electrical and fuel management system.
• GReddy Performance Products Inc. is not responsible for any damage to
the vehicle’s electrical system caused by improper installation.
• It is recommended to solder all wires and use electrical tape or shrink warp
to insulate the wire connections.