Sper Scientific 850038 Pure Water Meter - Manual (Page 24)

PARAMETER SETTING
a) P0.0: Print (Prn)
1. When the meter is in the normal mode,
press for more than two seconds
to enter to setup mode.
SET
2. Press to switch the setting
parameter one by one.
4. Press ENTER to enter each parameter
setting as follows:
or
3. Press ESC key to return to the previous
status.
b) P1.0: manual range setting (rAn)
Press the UP or KEYS to select
the ranging function, rAn. (Fig.P ).
When you see P1.0, press ENTER.
At P0.0, press ENTER to reach P0.1.
"Prn" will flash to indicate that the meter
is transmitting the memories through
its IrDA port to another device. ( Fig. O)
IrDA port to port should be at
less than 30 degree angle.
Normally, the meter will automatically
select a range when readings appear.
The manual ranging function allows
you to select a specific range and
and corresponding resolution.
This function is for COND and TDS
measurement. The Salinity range is
fixed. There are 5 ranges.
Fig. O
23