Sper Scientific 850038 Pure Water Meter - Manual (Page 22)

SALINITY MEASUREMENT
4.Start to take readings. Press "MODE"
to switch the meter to TDS mode.
(Fig. L)
READY
o
C
TDS
ppm
To chang the TDS factor to another
value, see Appendix B &C on page 41.
3. Select Range, automatic temperature
compensation or manual temperature
compensation per your application
by following steps on page18~20
.
Fig. L
ATC
I n SALT mode, the following fixed
conditions apply:
*Built-in NaCL conductivity to TDS
conversion factor.
*Temp. Coefficient.
o *Normalization Temp. (fixed at 25 C)
1. Taking measurements with READY
indicator activated:
If the READY indicator is activated,
"READY" is displayed when the
reading is stable. (Fig. M) .
To turn the READY indicator on or off
See P 2.2, page 25.
H:M:S
READY
o
C
SALT
ppt
Fig.M
ATC
H:M:S
21