Ridetech 41180000 - Manual (Page 7)

Air Ride Technologies
Seat Back
Torques
Head Bolt
Electrical
Connector
Lap Belt
Front
Facto
ry
Holes
Fron
t
Hex Head Bolts
Reinforcement
Rib
Drill Template
Mark Four Holes
To Be Drilled
5
41180000
70-73 Camaro TigerCage
Main Hoop Installation
Step 5. Disconnect the electrical connector
from the seat belt sensor. Using a T45 torques
wrench or socket remove the toques head bolt
securing the front seat lap belt to the floor pan.
Do both the driver and passenger sides
(See Fig 7).
Step . Remove the screw and washer at the
bottom of the seat back on both the driver and
passenger side and retain for reinstallation
(See Fig 6). Pull the bottom of the seat back
out and push in at the top while lifting up to
remove the seat back.
Step 7. Slip two 3/8” hex head bolts through
the holes in the supplied drill template marked
“Factory Holes”. Insert the two bolts into the
existing holes in the raised reinforcement rib
on the drivers side of the package tray
(See Fig 8). The front edge of the template
should be parallel to the edge of the package
tray. Mark the center point of the four holes to
be drilled in the top of the package tray and
remove the template.
NOTE: When marking the passenger side the
template will need to be turned over.
Step 6. Remove the rear window package tray
cover and sound pad exposing the sheet metal.
If your vehicle is equipped with rear speakers
that are attached to the package tray cover, it
will be necessary to remove them.
Fig 6
Fig 7
Fig 8