Ridetech 41180000 - Manual (Page 6)

Air Ride Technologies
Seat Belt
Retaining
Hoop
Seat Track
FRONT
SEAT
Seat Frame
Retaining
Clips
Retaining
Clip
Retaining
Clip
Floor Pan
Floor
Pan
Seat
Frame
PUSH
LIF
T P
U
S
H
SECTION A-A
REAR
SEAT
A A
41180000
70-73 Camaro TigerCage
Main Hoop Installation
Step . Remove the rear seat by firmly push-
ing down and back on the rear edge of the
seat cushion while lifting upward on the front
to release the seat frame from the retaining
clips located in the floor pan (See Fig 5).
Step . Remove the driver and passenger
front seats by removing the four bolts in the
seat tracks (See Fig 4). Retain the bolts for
reinstallation of the front seats
Step . Rotate the front seat belt retaining
hoops on both the passenger and driver side
seats 90 degrees and pull straight out to
remove the hoop from the seat (See Fig 3).
Slip the safety belt through the slot in the
hoop.
NOTE: Removal of the front seats is optional
but strongly recommended.
Fig
Fig
Fig 5