Allied Telesis AR800 Series User Manual
Page 6

6
Patch Release Note
Patch 86231-10 for Software Release 2.3.1
C613-10328-00 REV J
Sometimes the Agent Address field in SNMP traps was not the same as the 
IP source address. This meant that sometimes the NMS did not send an 
alarm to the network manager when traps were received from switches. 
This issue has been resolved.
The Uplink card sometimes unnecessarily changed its status from UP to 
DOWN. This issue has been resolved.
Dynamic interface details were added through the SET INTERFACE 
command when the CREATE CONFIGURATION command was executed. 
This caused errors on startup. This issue has been resolved.
Typing “?” after SET STP=stp-name at the CLI to request context-sensitive 
Help only returned the PORT and DEFAULT options. This issue has been 
resolved so that all options are shown.
DHCP sometimes suffered a fatal error when a range of IP addresses was 
destroyed. This issue has been resolved.
Critical files (prefer.ins, config.ins and enabled.sec) are now copied from NVS 
to FLASH at boot time if they do not exist in FLASH, or if the NVS version 
of the file is different from the FLASH version.
If the SET SWITCH L3FILTER MATCH command had nothing specified for 
the IMPORT and EMPORT parameters, and there was an existing match 
entry in the filter table, the new filter was not added correctly. Filter match 
entries are now accepted regardless of the order in which they are entered 
into the table.
IP routes deleted from the route cache occasionally caused a fatal error. This 
issue has been resolved.
Previously, the ADD SWITCH L3FILTER MATCH command was accepted 
if the TYPE parameter was not specified. This command now requires the 
TYPE parameter, and an error message will be returned if the TYPE 
parameter is not specified.
The ENABLE PPP DEBUG command was not accepting the ASYN 
parameter. This issue has been resolved.
PCR: 03346
Module: SNMP
Level: 4
PCR: 03348
Module: SWI
Level: 3
PCR: 03353
Module: PPP
Level: 3
PCR: 03360
Module: STP
Level: 4
PCR: 03378
Module: DHCP
Level: 2
PCR: 03385
Module: FILE, INSTALL, SCR
Level:
PCR: 03386
Module: SWI
Level: 2
PCR: 03402
Module: IPG
Level: 2
PCR: 03416
Module: SWI
Level: 3
PCR: 03417
Module: PPP
Level: 3
