Allied Telesis AR800 Series - Manual (Page 30)

30 Patch Release Note
Patch 86231-10 for Software Release 2.3.1
C613-10328-00 REV J
The CREATE CONFIG command now correctly configures tagged ports
belonging to VLANs not in the default STP.
The TCP port 00515 (LPD) is now closed by default until a CREATE LPD
command is executed. The port then remains open until a router restart.
The X.25 TCP listen port (01998) is now closed by default until a CREATE
X25C command or SET X25C TCPKEEPALIVE command is executed. The
port then remains open until a router restart.
The TCP listen port 05026 (STT) is now closed by default until a ADD STT
command is executed. The port then remains open until a router restart.
Improved the display of buttons when using the Netscape browser, and
improved the Modify VLAN page in the GUI.
Invalid values were presented when reading MIB variables from the STP
port table. This issue has been resolved.
Some Rapier products returned invalid sysObjectIds. This issue has been
resolved.
Special multicast packets (ie. 224.0.0.3 - 224.0.0.255) were sometimes not
recognised as being multicast packets. This issue has been resolved.
Some SNMP trap identifiers generated by a rising or falling alarm were
incorrect. This issue has been resolved.
Incoming multicast traffic from a source connected to a switch port
operating in multicast mode B (flood multicast packets with no registered
member) will no longer flood the VLAN associated with the port. Only
member ports and router ports on the same VLAN will receive the traffic.
PCR: 02035 Module: VLAN Network affecting: No
PCR: 02042 Module: LPD Network affecting: No
PCR: 02043 Module: X25 Network affecting: No
PCR: 02044 Module: STT Network affecting: No
PCR: 02045 Module: OGM Network affecting: No
PCR: 02047 Module: SWI Network affecting: No
PCR: 02048 Module: CORE Network affecting: No
PCR: 02049 Module: IPG Network affecting: No
PCR: 02050 Module: RMON Network affecting: No
PCR: 02056 Module: IGMP Network affecting: No