Allied Telesis AR800 Series - Manual (Page 5)

Patch 86231-10 For Rapier Switches and AR800 Series Modular Switching Routers 5
Patch 86231-10 for Software Release 2.3.1
C613-10328-00 REV J
If a DVMRP interface was deleted and then added again, DVMRP routes
associated with this interface were not reactivated. This issue has been
resolved.
A fatal error occurred when OSPF was under high load. This issue has been
resolved.
When deleting a list associated with a policy, all rules were being deleted.
Now only the rules associated with the policy and list are deleted.
The DELETE SWITCH FILTER command did not work properly when the
ENTRY parameter was assigned a range with hyphen (“-”). This issue has
been resolved.
The firewall doubled the IPSPOOF event timeout from 2 minutes to 4
minutes. This issue has been resolved.
Broadcast TCP packets were being processed by the device, causing fatal
errors when firewall SMTP Proxy was configured. Non-unicast TCP packets
are now dropped by IP.
The Designated Router (DR) of the PIM interface was not resetting when the
RESET PIM INTERFACE command was executed. This issue has been
resolved.
Packets processed by the firewall were not having their TTL decremented.
This issue has been resolved.
The PIM Designated Router (DR) is now elected over an entire VLAN
interface, rather than on a per-port basis.
After VRRP was enabled, the link status of the switch ports was shown as
UP, even if there was no connection to the ports. This issue has been
resolved.
“AT-A42” was being incorrectly displayed as “AT-A42X-00” in the output
of the SHOW SYSTEM command. This issue has been resolved.
PCR: 03217 Module: DVMRP Level: 2
PCR: 03240 Module: OSPF Level: 2
PCR: 03241 Module: FIREWALL Level: 2
PCR: 03250 Module: SWI Level: 4
PCR: 03255 Module: FIREWALL Level: 3
PCR: 03296 Module: IPG Level: 2
PCR: 03297 Module: PIM Level: 2
PCR: 03301 Module: IPG Level: 3
PCR: 03303 Module: PIM Level: 3
PCR: 03333 Module: IPG Level: 3
PCR: 03336 Module: CORE Level: 4