beautypg.com

Allied Telesis AR800 Series User Manual

Page 18

background image

18

Patch Release Note

Patch 86231-10 for Software Release 2.3.1

C613-10328-00 REV J

The virtual MAC address was used as the source MAC for all packets
forwarded on an interface associated with a Virtual Router (VR). This was
confusing when multiple VRs were defined over the same interface because
only one virtual MAC address was ever used. The other virtual MAC
addresses (for the other VR's) were only used if the source IP address
matched the VR’s IP address. To avoid this confusion, the system MAC
address is now always used unless the source IP address of the packet is the
same as the VR’s IP address.

PIM or DVMRP failed to see any data if IGMP snooping was on and
DVMRP or PIM was enabled after the data stream had reached the router/
switch. This issue has been resolved.

HTTP requests from a fixed IP address were erroneously reported as a host
scan attack in the Firewall deny queue. This issue has been resolved.

ARL message interrupts have been re-enabled after a software table rebuild
to fix synchronisation of the software forwarding database with the
hardware table.

Some routes were not added into the OSPF route list, and therefore were not
added into the IP route table. This issue has been resolved.

The CREATE CONFIG command did not save the SOURCEPORT
parameter to the configuration file when the low value of the source port
range was set to zero. This issue has been resolved.

Existing IGMP groups were not deleted when IGMP was disabled globally
or on the associated interface. This gave the groups very high timeout
values. This issue has been resolved.

IPSec no longer logs packets that match an ACTION=ALLOW policy. The
overhead of this logging was affecting non-IPSec traffic.

The ENCO key creation thread did not suspend to allow other processes
any CPU time. This caused the command prompt to freeze during key
creation. This issue has been resolved.

The LOCALRSAKEY parameter in the CREATE ISAKMP POLICY and SET
ISAKMP POLICY commands was not accepting the value zero. This issue
has been resolved.

PCR: 02263

Module: VRRP

Network affecting: No

PCR: 02264

Module: PIM, DVMRP, SWI

Network affecting: No

PCR: 02268

Module: FIREWALL

Network affecting: No

PCR: 02274

Module: TPAD

Network affecting: No

PCR: 02275

Module: OSPF

Network affecting: No

PCR: 02276

Module: FIREWALL

Network affecting: No

PCR: 02287

Module: IPG

Network affecting: No

PCR: 02292

Module: IPSEC

Network affecting: No

PCR: 02293

Module: ENCO

Network affecting: No

PCR: 02294

Module: IKMP

Network affecting: No