Allied Telesis AR800 Series - Manual (Page 3)

Patch 86231-10 For Rapier Switches and AR800 Series Modular Switching Routers 3
Patch 86231-10 for Software Release 2.3.1
C613-10328-00 REV J
The standard subnet NAT rules on a private interface were not matching a
packet unless its source IP address was exactly the same as the IPADDRESS
value set for the rule, that is the NAT mask value was not being used. This
issue has been resolved.
The ADD FIREWALL POLICY and SET FIREWALL POLICY commands
did not generate a valid port list when the optional PORT parameter was set
to ALL. This issue has been resolved.
When OSPF was enabled on startup, an OSPF interface would sometimes
stay in the DOWN state. This issue has been resolved.
The size of the 86231 patch file was causing issues. This has been resolved.
The SET INSTALL command was generating an unwanted warning
message on the Rapier i series switches. This issue has been resolved.
When ports were added to a trunk group on a Rapier 16, the ports operated
in the wrong duplex mode. This issue has been resolved.
After setting the IGMP query timer with the SET IP IGMP command, and
saving the configuration, the IGMP Other Querier timeout was not set to the
correct value after a restart. This issue has been resolved.
Entries in the process of being reclaimed as static entries (and waiting for
the remote IP to become routable), were disrupting the reclaim process. This
prevented further entries from being reclaimed. DHCP static entries are
now fully subject to normal reclaim processing.
Sometimes IP flows were not deleted correctly when both directions of the
flow were in use. This issue has been resolved.
PIM join messages were being sent by a switch connected to an upstream
and a downstream switch or router in the same VLAN when a multicast
group had no members. This issue has been resolved.
When the TX cable was unplugged from a fibre port the operating status
was incorrectly reported as UP. This issue has been resolved.
PCR: 02550 Module: FIREWALL Network affecting: No
PCR: 02579 Module: FIREWALL Network affecting: No
PCR: 02587 Module: OSPF Network affecting: No
PCR: 03009 Module: CORE Level: 2
PCR: 03013 Module: INSTALL Network affecting: No
PCR: 03015 Module: SWI Network affecting: No
PCR: 03026 Module: IPG Network affecting: No
PCR: 03027 Module: DHCP Network affecting: No
PCR: 03040 Module: IPG Network affecting: No
PCR: 03042 Module: PIM Level: 3
PCR: 03065 Module: SWI Level: 2