Allied Telesis AR800 Series - Manual (Page 28)

28 Patch Release Note
Patch 86231-10 for Software Release 2.3.1
C613-10328-00 REV J
When the switch received an IGMP query, it created an entry in the
hardware-based multicast table that had incorrect port tagging information.
This issue has been resolved. Also, IGMP will no longer participate in
changing the hardware multicast table when IP multicast switching
emulation is enabled.
STP always transmits untagged packets. If a port does not belong to a
VLAN as an untagged port, then the port must belong to one VLAN as a
tagged port. In this case, STP should transmit VLAN tagged packets out of
the port.
A switch sometimes restarted if it was configured with static DHCP entries
and was handling a large number of DHCP clients. This issue has been
resolved.
When a VLAN was configured as a PIM interface, and had trunked ports as
members, PIM did not work properly on the trunked ports. This issue has
been resolved.
The layer 3 hardware table was not sorted properly when it contained a
very wide range of IP addresses (eg. 10.0.0.1 - 205.33.3.1). This caused a
small number of packets to be routed by software rather than hardware.
This issue has been resolved.
IPX traffic passing between two switch instances using VLAN for Rapier48
now operates correctly.
The periodic and time trigger counts were incrementing by two instead of
one on each update. This issue has been resolved.
The ADD IP ARP command can now accept ports 49 and 50.
PCR: 02096 Module: IPG, SWI Network affecting: No
PCR: 02098 Module: STP Network affecting: No
PCR: 02099 Module: DHCP Network affecting: No
PCR: 02100 Module: PIM Network affecting: No
PCR: 02101 Module: SWI Network affecting: No
PCR: 02103 Module: SWI Network affecting: No
PCR: 02104 Module: TRG Network affecting: No
PCR: 02106 Module: IPG Network affecting: No