ididit Right Hand Drive & Collapsible Steering Column: RHD Tri-Five Chevy - Manual (Page 7)

Cut approximately 6” up
from the box and work
your way down until
the column is properly
positioned in your dash.
(See “Synchronizing Your
Column” on page 7.)
The coupler is pre-welded the 1” DD side to
go on the column, two flat sides ground onto
stock 3/4” shaft (coming out of gear box) to
make it 3/4” DD to fit into other side of coupler
3/4” DD x 1” DD coupler, this coupler will be held to the column
with two set screws, installed at a 90° angle to each other.
I
nstallatIon
I
nstructIons for the
c
lassIc
1955-56-57
c
hevy
– t
Ilt
s
teerIng wIthout
c
olumn
s
hIft
, u
sIng
s
tock
g
ear
B
ox
PART #3000315249
ORIGINAL STEERING SHAFT
MADE IN TO A 3/4” DD BY
GRINDING TWO FLATS.
3/4” DD TO 1” ADAPTOR
TILT COLUMN WITHOUT SHIFTER
1” DD SHAFT FROM THE
NEW STEERING COLUMN
Column
6