ididit Right Hand Drive & Collapsible Steering Column: RHD Tri-Five Chevy - Manual (Page 5)

4
Wiring your Column
This ididit steering column uses a standard 3 7/8-inch male connect. How-
ever, some GM columns use a 4 ¼-inch male connector. Connectors do
not interchange and must be used in pairs. A mate to the 3 7/8 inch plug is
available through ididit. If you need to change this connector for any rea-
son the following schematic will be helpful.
Horn Button Wiring:
A horn may require two wires to properly function
with an ididit column. The center lug on the button
should connect to a horn wire, which is provided
by ididit with your steering column. This horn wire
will slide into the horn cam (white plastic tube
sticking up on the top of the column). If there is a
second wire off to the side it is probably a ground
wire (check with the horn button manufacturer to
be sure). This is normally used when an o-ring is used to hold the button
in place. The o-ring does not provide sufficient ground, therefore, an ad-
ditional wire is provided to ground the horn button. If there is not a hole in
adaptor to ground to, use one of the puller holes with a short bolt to attach
the wire to the adaptor.
Synchronizing your Column
In order to ensure proper functioning, this steering column must be installed in
sync with the rest of the steering system. Signal cancellation and wheel posi-
tion, as well as smooth steering operation depends on it. Although not all of
them may need adjustment, the complete list of steps required for full synchro-
nization is as follows: (continued on next page):