Ididit – ididit Retrofit Steering Column: 1967-69 Chrysler B-Body User Manual

Page 8

Emergency Flasher
The Emergency flasher is threaded into the hole
located on the right side of the column. You
will noticed the plastic portion that the flasher
screws into is flush with the outer surface when
the flashers are in the off position. It is easy to
accidently turn the flashers ON while installing
which could lead to problems later. Check to
make sure the flashers are in the OFF position
before continuing.

Turn Signal Lever
A screw is provided with the Dress-up kit. This
screw with secure the turn signal lever to the
column.

PLEASE NOTE there are two holes

on the turn signal switch. One D shaped and the
other is round. The screw is to be inserted in the
round hole! Use a #2 Phillips screw driver to
tighten this screw tightly. It holds the lever and
the switch half’s together.

Need Further Assistance?

ididit, inc has been serving the rodding

community for over 25 years and we

take pride in our outstanding customer

service. If you need further assistance,

feel free to call us at (517)424-0577,

Monday-Friday from 8:30 am - 5:30 pm

and Saturday 10:00 am - 2 pm EST. You

can also email us at [email protected].

No part of this guide may be reprinted, reproduced or utilized in

any form without the express written permission of ididit, inc.

2012 ididit, inc.

Printed in the USA

ididit,

inc.

610 S. Maumee St., Tecumseh, MI 49286

(517) 424-0577 • (517) 424-7293 fax