ididit Retrofit Steering Column: 1970-75 Camaro - Manual (Page 6)

4
Knobs & Levers:
Tilt Lever: After removing all items from the package, screw the
knobs onto the levers. The tilt lever is installed on the left side of
the column in the threaded hole located closest to the dash. We
recommend using Locktite.
Emergency Flasher: The Emergency flasher is threaded into the
hole located on the right side of the column. You will noticed the
plastic portion that the flasher screws into is flush with the outer
surface when the flashers are in the off position. It is easy to
accidently turn the flashers ON while installing which could lead to
problems later. Check to make sure the flashers are in the OFF
position before continuing.
Turn Signal Lever: A screw is provided with the Dress-up kit. This
screw with secure the turn signal lever to the column. PLEASE
NOTE there are two holes on the turn signal switch. One D shaped
and the other is round. The screw is to be inserted in the round
hole! Use a #2 Phillips screw driver to tighten this screw tightly. It
holds the lever and the switch half’s together. (See Figure 12, 13,
14)
(Figure 12) (Figure 13)
(Figure 14)