ididit Universal Steering Column: Universal Straight User Manual

Page 3

How to install your Turn Signal Levers and Hazard Knob

Turn Signal Lever:

The signal lever is the lever closest to the top

of the column. With the steering wheel and

adaptor removed, look down from the top

of the column and you’ll see where a single

screw holds the signal lever in place. Insert

the new lever using the provided screw into

round hole (not D shaped hole). When install-

ing this lever in a new column, use the screw

supplied to fasten the lever in the recessed

area on the signal switch arm.

Emergency Flasher Knob:

Almost directly opposite the turn lever on the steer-

ing column is another opening. Inside this opening

is a hole in the nylon switch. Simply screw the

new knob in place (clockwise). When complet-

ing installation of flasher knob make sure that the

knob is in the out (off), position so when finished

wiring you don’t have any complications.

If Column Shift Application:

Place column shift knob onto the shift lever.

Once your lever is on , use setscrew (provided)

and adjust knob so set screw is not facing for-

ward, tighten setscrew. Do not remove the upper

shift lever for any reason! The tension spring

will pop out and it is very difficult to re-install.