Extang Tuff Tonno: Ford Sport Trac - Manual (Page 2)

Extang Corporation, 1901 E. Ellsworth Rd., Ann Arbor, MI 48108, 734 677-0444, Fax: 734 677-8409, Visit us at: www.extang.com
8
7
Insert bow onto top or bottom peg.
(Top peg for performance, Bottom for good looks.)
Ends are spring loaded
for easy installation.
Push and hold on
spring end and let the
other end slide on with
the spring action.
SPECIAL
FEATURE:
Two pegs
offer two
height
adjustments.
Note:
Bow End does not
fit between pegs.
EASY USE OF TRUCK BED
Tarp may be rolled up and secured with
Velcro® for bulk hauling
6
Side Rail Clamping (Same for each side)
Remove two hex socket screws from the inside of the Sport Trac payload bed. Place
Sport Trac Bracket over screw hole and replace with provided metric screws and
secure firmly into bed wall with metric wrench.
Top each bracket with a rail
clamp, (long-neck at the cab
end, and short-neck at the
tailgate end), and secure with
a clamp bolt.
Note: Insert side rail
clamp all the way
into rail.
A. Release lever on both corners of
tailgate rail and tilt rail up.
D. Finish attaching tarp along each side by
pushing down and sliding you hand towards
each corner. You can feel the “grip” action. C. Close-up of downward rotation of rear
rail. You will feel the “snap” effect and see
it tighten snugly.
PUSH
DOWN
PRESS & SLIDE
YOUR HAND
B. Attach tarp at front by pressing
down on edge of tarp with the palms
of your hands (about only 12 inches
on each side). Then hook tarp to the
tails rail’s groove and click down to
tighten tarp. See close-up.
Upper
Peg
Lower
Peg
Do Not
Place
Between
the Pegs
Short Neck
Clamp
Long Neck
Clamp
5
Place the rail assembly over the side of the truck
box. Center rails evenly between cab and tailgate.