EOTech CNVD-T (SU-232/PAS) Clip-On Night Vision Device - Thermal - Manual (Page 49)

3-7
Figure 3-3 Replacing Battery Door Lanyard
f. Apply a small bead of Vibra-Tite® (or equivalent) to
the threads of the mounting screw and use a T-7
Torx wrench to install.
3.3.4 Replacing Video Jack Plug Assembly . Vibra-Tite® (or
equivalent) and a T-7 Torx wrench are required to perform
this procedure.
a. Turn the video jack plug counterclockwise until it is
unscrewed from the video jack.
NOTE
Because the lanyard mounting screw is installed at
the factory with a small amount of bonding
material, it is normal to encounter resistance when
removing it.