EOTech CNVD-T (SU-232/PAS) Clip-On Night Vision Device - Thermal - Manual (Page 24)

2-8
2.6 POWER
Pressing the POWER button will turn the unit on. The
CNVD-T will power up with the same settings selected as
when the system was last turned off.
With the system powered on, the CNVD-T can be placed in
a Standby Mode by pressing and holding the MENU / ZOOM
button for about 3 seconds. Pressing any of the LEFT /
RIGHT / UP / DOWN buttons will reactivate the unit. Upon
“waking” from Standby Mode, the unit will retain all settings
entered by the operator prior to being placed in standby.
Standby Mode decreases power consumption by
approximately 10% by shutting off the eyepiece display.
NOTE
In Standby Mode, the CNVD-T will continue to
draw a significant amount of power that will
eventually drain the batteries. The unit should be
turned off if it is not expected to be used.
To turn off, press and hold the POWER button for
approximately 3 seconds as the messages OFF? then OFF!
appear sequentially in the eyepiece display. Release the
POWER button when the eyepiece display turns dark.
2.7 BUTTON FUNCTIONS
The CNVD-T buttons are multifunctional and produce
different results depending on how they are pressed and
whether or not the Main Menu is displayed.
2.7.1 MENU / ZOOM Button . The MENU / ZOOM button
has a raised dimple that allows it to be easily identified by
touch.