EOTech CNVD-T (SU-232/PAS) Clip-On Night Vision Device - Thermal - Manual (Page 47)

3-5
3.3.2 Replacing Objective Lens Cover and Lens Cover
Strap . No tools are required to perform this procedure.
a. Pull both ends of the existing strap off their
respective retaining pins (located on the CNVD-T
housing).
b. While holding the lens cover in one hand, use the
other hand to pull the strap over, and off, the center
stud of the lens cover.
c. Work the large, center eye of the replacement strap
over the center stud of the lens cover, ensuring it
lays flat against the surface with the glossy side
down.
d. Loop one of the strap’s smaller eyes over one of the
retaining pins.
e. Lead the strap’s remaining eye over the top of the
housing as shown in Figure 3-2 and loop it over the
other retaining pin.
Figure 3-2 Replacing Objective Lens Cover
f. Flip the lens cap down and over the objective lens.