EOTech CNVD-T (SU-232/PAS) Clip-On Night Vision Device - Thermal - Manual (Page 28)

2-12
2.11 STARTUP PROCEDURES
To achieve optimal performance and image clarity, the
following procedures should be accomplished in the order
presented, each time the CNVD-T is to be placed into
operation:
a. Install batteries per paragraph 2.2.2.
b. Turn on the CNVD-T by pressing the
POWER
button. Wait 2 to 5 seconds until the system begins
imaging.
c. Install the objective lens cover and perform a
calibration as described in paragraph 2.12.3.
d. Flip up the objective lens cover and adjust the
brightness setting to a comfortable viewing level as
described in section 2.8.
e. Adjust the contrast (gain) setting to a comfortable
viewing level as described in section 2.9.
f. While looking through the eyepiece at an object at
least one meter away, rotate the objective focus ring
until the best (sharpest) thermal image is obtained.
2.12 MENU FUNCTIONS
With the CNVD-T turned on, access the Main Menu by
pressing the MENU / ZOOM button. The Main Menu will
appear in the eyepiece display as shown below.
Figure 2-7 Main Menu
ZOOM 1X
POL
CAL
RETINT
RET
RS170
EXIT