EOTech CNVD-T (SU-232/PAS) Clip-On Night Vision Device - Thermal - Manual (Page 33)

2-17
be placed in an auto-intensity mode by repeatedly pressing
the UP button until the status bar is at the extreme upper
(WHITE) end of scale and the word AUTO appears.
2.12.5 Reticle (RET) . Activating the RET menu item allows
for repositioning the reticle and toggling it on or off.
Figure 2-13 Menu – Reticle (RET) Control
Once selected, the following sub-menu will appear in the
eyepiece display:
2.12.5.1 Activating the POS (position adjustment) sub-menu
item allows for adjusting the position of the reticle in the
eyepiece display.
a. Adjustments are made using the UP / DOWN / LEFT
/ RIGHT buttons. When adjusting reticle position,
AZ (azimuth) and EL (elevation) values appear in
the lower left corner of the display as shown in
Figure 2-14. The numbers represent “clicks” of the
reticle. Azimuth and elevation values can rapidly be
returned to 0 by pressing the UP and DOWN buttons
or the LEFT and RIGHT buttons simultaneously.
EXIT POS OFF
ZOOM 1X
POL
CAL
RETINT
RET
RS170
EXIT