BMR Suspension STB012 User Manual
Page 3
17. Plug the ABS harness back into the ABS unit and secure it by sliding the lever down.
18. Push the ABS unit back down into the proper position and re-install the two 10mm nuts.
Tighten.
19. Clip the brake lines back into position.
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this
vehicle. As such, Buyer assumes all risk of any caused to the vehicle/person during installation or use of this
product.
3
See also other documents in the category BMR Suspension For the car:
- AA016 (2 pages)
- AA017 (1 page)
- AA018 (3 pages)
- AA028 (1 page)
- AA005 (3 pages)
- BCA005 (1 page)
- BK043 (2 pages)
- CCK002 (3 pages)
- RB001 (2 pages)
- RSK001 (1 page)
- RSK007 (2 pages)
- SB035 (3 pages)
- BCA003 (1 page)
- XSB006 (1 page)
- DSL002 (2 pages)
- TCA007 (1 page)
- AWK-1 (1 page)
- PSB001 (1 page)
- TCA018 (1 page)
- BCK003 (4 pages)
- BK046 (4 pages)
- BK006 (1 page)
- BK008 (1 page)
- BK016 (3 pages)
- BK017 (4 pages)
- BK018 (2 pages)
- BK019 (1 page)
- BK024 (4 pages)
- BK026 (4 pages)
- BK027 (5 pages)
- BK029 (4 pages)
- BK039 (4 pages)
- BK040 (3 pages)
- CCK004 (2 pages)
- DSL014 (2 pages)
- DSL015 (1 page)
- DTB004 (1 page)
- ELK004 (1 page)
- ELK005 (1 page)
- ELK006 (1 page)
- ELK009 (1 page)
- ELK011 (1 page)
- MM004 (2 pages)
- MTCA030 (2 pages)
- S5003 (4 pages)