BMR Suspension SFC013 - Manual (Page 2)

2
6. Once all bolts are inserted, tighten the four Allen bolts to 45 ft/lbs.
7. Remove the 10mm tunnel brace bolts installed in the previous step.
8. Repeat steps 5-6 for the other subframe connector.
9. If re-using the factory tunnel brace, it is necessary to modify the brace for re-installation. Begin by
measuring 2” from each end and marking the tunnel brace for cutting. As shown in Image 5, cut along
the previous mark using a bandsaw, hacksaw,
or cut-off wheel. Re-install tunnel brace over
the subframe connectors and thread the 10mm
bolts back into place. Tighten bolts to 45
ft/lbs. NOTE: BMR heavy duty tunnel brace
shown below is highly recommended to take
full advantage of the subframe connectors.
When using this brace, no modifications are
necessary.
10. Lower vehicle.
Image below shown with optional BMR tunnel brace installed.
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As such,
Buyer assumes all risk of any caused to the vehicle/person during installation or use of this product.