BMR Suspension SB013 - Manual

PONTIAC G8 REAR SWAY BAR INSTALLATION
SB013 – 2008-PRESENT PONTIAC G8
RECOMMENDED TOOLS:
15mm
wrench
13mm socket
3/8” drive ratchet
INSTALLATION:
1. Lift vehicle and support safely under frame rails.
2. Using a 15mm wrench, loosen the center exhaust hanger and pull
the hanger off the mounting stud. This will allow the exhaust to
drop slightly and provide enough room to remove the sway bar.
(IMAGE 1)
3. Using a 4mm Allen wrench and a 15mm wrench, remove the nuts
from the sway bar end links. NOTE: the Allen wrench is only
necessary to prevent the center stud of the end link tie rod from
spinning while removing the nut. (IMAGE 2)
4. Using a 13mm socket, remove the bolts that hold the sway bar to
the rear suspension cradle. (IMAGE 3)
5. Remove the sway bar.
6. Remove the OE sway bar brackets from the stock sway bar and
install them onto the BMR sway bar as shown in IMAGE 4.
7. Position the BMR sway bar into place and thread the factory
mounting bolts into place. Tighten.
8. Insert the end links into the sway bar and tighten both nuts.
9. Re-install the exhaust hanger over the mounting stud. Tighten
mounting nut.
10. Lower vehicle.
WWW.BMRFABRICATION.COM
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As such, buyer assumes all risk of
any damage caused to vehicle/person during installation or use of this product.
1