BMR Suspension RS003 - Manual (Page 2)

2
TUBULAR RADIATOR SUPPORT INSTALLATION
RS003 – 2005-Present Mustang
(CONTINUED)
6. Remove the radiator mounting bushings from the OE radiator support and insert them into the BMR Tubular Radiator
Support as shown in IMAGE 4.
7. Install the BMR Tubular Radiator Support using the OE mounting bolts. Tighten all four bolts to 75 ft/lbs. (IMAGE 5)
8. Using the supplied 3/8” x 1.25” bolts, nuts, and washers, re-install the sway bar to the new BMR Tubular radiator Support.
Tighten bolts to 45 ft/lbs as shown in IMAGE 6.
9. Re-install the OE or BMR Radiator Support Chassis
Brace using the supplied 3/8” x 1” bolts, nuts, and
washers. Tighten bolts to 45 ft/lbs. See IMAGE 7.
10. The plastic panel covers can be left off the vehicle or
zip-tied to your BMR Radiator Support.
11. Lower vehicle.
WWW.BMRSUSPENSION.COM
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As such, buyer assumes all risk of
any damage caused to vehicle/person during installation or use of this product.