BMR Suspension DSL003 User Manual
BMR Suspension For the car
G-BODY DRIVESHAFT LOOP INSTALLATION
Part # DSL003
Tools Required:
Jack
Jack
Stands
13mm
wrench
11mm
wrench
Installation:
1. Lift the vehicle and support with jack stands under the frame rails.
2. Using the 11mm wrench, remove the driveshaft and tape the cups onto the u-joint to avoid
needle bearing loss.
3. Using the 13mm wrench, remove the OE chassis brace that is located just behind the
transmission tail-shaft.
4. Place the driveshaft loop into position where the OE brace was bolted with the loop facing
upwards. Insert the bolts and tighten.
5. Reinstall the driveshaft and tighten the u-joint bolts.
6. Lower vehicle.
WWW.BMRFABRICATION.COM
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As such, Buyer
assumes all risk of any damage caused to the vehicle or person during installation or use of this product.