BMR Suspension RK002 User Manual
Page 4
BMR MANUAL RACK CONVERSION KIT (Cont.)
PART# RK002
NOTE: In certain applications
it
may be necessary
to clearance the plastic on the back of the
alternator slightly to gain an adequate amount of
clearance.
At this point the vehicle should be taken to an
alignment shop. Once the toe is properly set, an
experienced alignment technician can fine tune the
bump-steer by adding or removing spacers at the
outer tie rod bolt. As a general rule of thumb to
keep bump-steer minimized, the angle of the tie
rod should parallel the lower A-arm as close as
possible.
NOTE:
Various length spacers are
provided for varying ride heights. It is not
necessary to use all of the spacers in every
application.
WWW.BMRSUSPENSION.COM
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this
vehicle. As such, buyer assumes all risk of any damage caused to the vehicle/person during installation/use
of this product.
4