BMR Suspension AA020 - Manual (Page 2)

2
F-BODY A-ARM INSTALLATION PICTURES
Part #’s AA001, AA002, AA004, AA020
18. Reinstall the spindle/rotor assembly and install new cotter pins. NOTE: Some aftermarket brake kits
may interfere with the ball joint cup of the A-arm. In this instance it is necessary to clearance the ball
joint cup in the appropriate area.
19. Reinstall the caliper.
20. Plug the ABS sensor in and route the ABS wire along the back tube of the A-arm. Zip tie the wire to
the A-arm.
21. Check to make sure all bolts are tight and reinstall wheels/tires.
NOTE: In some racing applications using adjustable coil-over type struts it may be necessary to add
additional ride height to the vehicle. BMR manufactures aluminum strut spacers in ½” increments to lift the
vehicle up to 1”, if necessary. These can be ordered direct under part # SA002.
NUMBERS CORRESPOND TO STEPS ON THE INSTRUCTION SHEET.
WWW.BMRFABRICATION.COM
This product is an aftermarket accessory and not designed by the vehicles
manufacturer for use on this vehicle. As such, buyer assumes all risk of any
damage caused to vehicle/person during installation or use of this product.