BMR Suspension SFC009 - Manual (Page 2)

PAGE 2
13. Begin by holding one of the tubes up into the approximate position and start trimming the ends a little at a time until you get
a good fit from the sub-frame connector to the inner frame rail. Try to stagger the tubes on the frame rail providing as much
exhaust clearance as possible. See images to the right for examples.
14. Once the two frame reinforcements have been properly fit, grind the sub-frame and the sub-frame connector at the weld
points and weld into place.
15. Wire brush and paint all weld points and re-install the exhaust if previously removed.
16. Tighten the control arm bolt to 100 ft/lbs.
17. Lower vehicle.
BMR Subframe connectors ship with additional reinforcement plates that may be welded in if desired. They are designed to join the
factory pinch welds on the rocker panels to the Subframe Connectors. The reinforcement plates are not necessary for light duty street
applications but are recommended for aggressive road racing, high horsepower drag racing applications or when using the BMR Trak
Pak or Xtreme Duty torque arms with weld-in cross-member. See image below for installation example.
WWW.BMRFABRICATION.COM
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As such, buyer
assumes all risk of any damage caused to the vehicle/person during installation or use of this product.
PAGE 2