BMR Suspension SFC015 - Manual (Page 2)

2
SFC015 - 2010-Present CAMARO
SUBFRAME CONNECTOR INSTALLATION (continued)
9. If re-using the factory tunnel brace, it is necessary to modify the brace for re-installation. Begin by
measuring 2” from each end and marking the tunnel brace for cutting. As shown in Image 5, cut along
the previous mark using a bandsaw, hacksaw, or cut-off wheel. Re-install tunnel brace over the subframe
connectors and thread the 10mm bolts back into place. Tighten bolts to 48 ft/lbs. NOTE: BMR heavy
duty tunnel brace shown below is highly recommended to take full advantage of the subframe connectors.
When using this brace, no modifications are necessary.
10. Lower vehicle.
Above image shown with optional BMR tunnel brace installed.
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As such,
Buyer assumes all risk of any caused to the vehicle/person during installation or use of this product.