BMR Suspension MM004 - Manual (Page 2)

MM004 – INSTALLATION INSTRUCTIONS
CONTINUED
8. Mount the stand/BMR mount assembly to the block using the OE mounting hardware. Torque the bolts to 45 ft/lbs.
9. Lower the motor back down until the mounts are sitting on the sub-frame. NOTE: Your BMR motor mounts will
automatically lower the motor ¼”, providing extra hood clearance for blowers and a lower center of gravity. If you do not
wish to lower your motor, use the provided ¼” aluminum spacer between the motor mount and engine cradle. Insert the
provided 12mm x 90mm bolts from the top, down through the BMR mount and sub-frame. NOTE: you may need to use an
alignment punch or screwdriver to align the holes. Tighten to 75 ft/lbs using an18mm and 19mm wrench.
10. Re-install the air box assembly. Lower vehicle.
WWW.BMRSUSPENSION.COM
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As such, buyer assumes all risk of
any damage caused to vehicle/person during installation or use of this product.
2