BMR Suspension BK029 - Manual (Page 3)

Differential Mount Bushings (Cont.)
11. Using a 10mm socket, remove the rear driveshaft tunnel exhaust shield.
12. Place a jack under the rear of the differential.
13. Note the orientation of the differential mounting bolts and make notes for proper re-
assembly (Image 10). Using an 18mm wrench and socket, remove the (3) mounting
bolts.
14. Place some rags between the inner CV boots and the cradle to protect the boot then lower
the differential to gain access to the front
mounting bushings.
15. Using a 2” hole saw, drill the front rubber
bushings out of the bushing shells. See
Image 11.
16. Using a screwdriver, pry the aluminum
bushing shell out of the differential
housing. See Image 12.
17. Insert the BMR bushing halves into the
housing. Grease the inside of the bushing
then knock the sleeves into the bushings.
18. Raise the front back up into the mount and
allow the rear to hang until the rear bushing
is accessible. Duplicate the above procedure for the rear mount. See Image 13.
3