BMR Suspension BK026 User Manual
Page 2
Differential Mount Bushings (Cont.)
5. Using a 13mm socket, remove the two bolts that hold the rear two muffler brackets in
place. Remove 4 bolts total, 2 per side. See Image 4 above.
6. Using a 15mm socket, remove the 4 front flange bolts on the exhaust (2 per side). See
Image 5 above.
7. Remove center 15mm exhaust hanger bolt in rear. See Image 6 above.
8. Using a helper, remove the entire exhaust assembly.
9. Using a 10mm socket, remove the front
driveshaft tunnel exhaust shield. See
Image 7 above.
10. Using an 18mm wrench and socket,
remove the 3 bolts that connect the
driveshaft flex joint to the differential. See
Image 8. NOTE: Remove the appropriate
bolts so that the rubber flex joint remains
attached to the driveshaft, NOT the
differential. Using a pry-bar, pry the joint
off the alignment dowel allowing the shaft
to hang out of the way. (Image 9).
2
- AA016 (2 pages)
- AA017 (1 page)
- AA018 (3 pages)
- AA028 (1 page)
- AA005 (3 pages)
- BCA005 (1 page)
- BK043 (2 pages)
- CCK002 (3 pages)
- RB001 (2 pages)
- RSK001 (1 page)
- RSK007 (2 pages)
- SB035 (3 pages)
- BCA003 (1 page)
- XSB006 (1 page)
- DSL002 (2 pages)
- TCA007 (1 page)
- AWK-1 (1 page)
- PSB001 (1 page)
- TCA018 (1 page)
- BCK003 (4 pages)
- BK046 (4 pages)
- BK006 (1 page)
- BK008 (1 page)
- BK016 (3 pages)
- BK017 (4 pages)
- BK018 (2 pages)
- BK019 (1 page)
- BK024 (4 pages)
- BK027 (5 pages)
- BK029 (4 pages)
- BK039 (4 pages)
- BK040 (3 pages)
- CCK004 (2 pages)
- DSL014 (2 pages)
- DSL015 (1 page)
- DTB004 (1 page)
- ELK004 (1 page)
- ELK005 (1 page)
- ELK006 (1 page)
- ELK009 (1 page)
- ELK011 (1 page)
- MM004 (2 pages)
- MTCA030 (2 pages)
- S5003 (4 pages)