BMR Suspension BK001 User Manual
Page 2

Differential Mount Bushings (Cont.)
5. Using a 13mm socket, remove the two bolts that hold the rear two muffler brackets in
place. Remove 4 bolts total, 2 per side. See Image 4 above.
6. Using a 15mm socket, remove the 4 front flange bolts on the exhaust (2 per side). See
Image 5 above.
7. Remove center 15mm exhaust hanger bolt in rear. See Image 6 above.
8. Using a helper, remove the entire exhaust assembly.
9. Using a 10mm socket, remove the front
driveshaft tunnel exhaust shield. See
Image 7 above.
10. Using an 18mm wrench and socket,
remove the 3 bolts that connect the
driveshaft flex joint to the differential. See
Image 8. NOTE: Remove the appropriate
bolts so that the rubber flex joint remains
attached to the driveshaft, NOT the
differential. Using a pry-bar, pry the joint
off the alignment dowel allowing the shaft
to hang out of the way. (Image 9).
2