BMR Suspension CCK002 User Manual
Page 3
3
COIL-OVER CONVERSION KIT INSTALLATION
CCK002 – 1964-1972 A-BODY
11. Weld the outside of the brackets with the coil-over bolted
in place to insure that the brackets do not draw inward and
lose concentricity. See IMAGE 8.
12. Remove the coil-over and weld the remaining portions of
the bracket in all accessible areas.
13. Wire wheel and prep the area then seal with a rust-
preventive primer. IMAGE 9
14. Paint entire area then re-assemble suspension.
WWW.BMRSUSPENSION.COM
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As such, buyer assumes all risk of
any damage caused to vehicle/person during installation or use of this product.
See also other documents in the category BMR Suspension For the car:
- AA016 (2 pages)
- AA017 (1 page)
- AA018 (3 pages)
- AA028 (1 page)
- AA005 (3 pages)
- BCA005 (1 page)
- BK043 (2 pages)
- RB001 (2 pages)
- RSK001 (1 page)
- RSK007 (2 pages)
- SB035 (3 pages)
- BCA003 (1 page)
- XSB006 (1 page)
- DSL002 (2 pages)
- TCA007 (1 page)
- AWK-1 (1 page)
- PSB001 (1 page)
- TCA018 (1 page)
- BCK003 (4 pages)
- BK046 (4 pages)
- BK006 (1 page)
- BK008 (1 page)
- BK016 (3 pages)
- BK017 (4 pages)
- BK018 (2 pages)
- BK019 (1 page)
- BK024 (4 pages)
- BK026 (4 pages)
- BK027 (5 pages)
- BK029 (4 pages)
- BK039 (4 pages)
- BK040 (3 pages)
- CCK004 (2 pages)
- DSL014 (2 pages)
- DSL015 (1 page)
- DTB004 (1 page)
- ELK004 (1 page)
- ELK005 (1 page)
- ELK006 (1 page)
- ELK009 (1 page)
- ELK011 (1 page)
- MM004 (2 pages)
- MTCA030 (2 pages)
- S5003 (4 pages)