BMR Suspension BK044 - Manual (Page 2)

2
BK043, BK044, and BK045 INSTALLATION INSTRUCTIONS
Continued
7.
If you have any of the tools shown above, install the BMR bushings into the housing. If you
do not have any of these tools the bushings may be installed by the following method: knock
the center sleeve out of the bushing using a punch and a hammer. Now push the polyurethane
bushing out of the
outer steel sleeve.
Knock the outer steel
sleeve into the
housing using a dead
blow hammer or a
regular hammer with
a block of wood
(IMAGE 1). The
sleeve is positioned
properly once the
stepped portion of the sleeve bottoms out on the ear of the rear end. Now re-install the
polyurethane bushing and center sleeve. The outer polyurethane “rings” go over the smaller
portion of the bushing once it has been installed. NOTE: on some axle housings the body of
the housing is too large to allow the use of this ring.
8. Lube the bushing mounting surfaces using the supplied grease.
9. Lift the rear end and re-install the shocks.
10. Re-install the upper control arms then lower the vehicle.
WWW.BMRSUSPENSION.COM
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As such, buyer
assumes all risk of any damage caused to vehicle/person during installation or use of this product.