AirSep MN166-1 B - Manual (Page 29)

25 MN166-1 rev B
Filter
Air Intake Filter
At least one time each week, remove the cover on the lower front of the unit, and wash the air intake filter, which is
positioned on the inside of the cover. (refer to filter section of this manual) Your Equipment Provider may advise you to
clean it more often, depending upon your operating conditions. Follow these steps to properly clean the air intake filter:
1. Remove the filter from the air intake filter cover, and wash it in a warm solution of soap and water.
2. Rinse the filter thoroughly, and remove excess water with a soft, adsorbent towel. Ensure that the filter is dry
before replacing it.
3. Replace the dry filter.
Do not operate the Oxygen Concentrator without the air intake filter in place. If a second filter is provided,
insert the “replacement” filter before you clean the dirty filter. Clean the dirty filter in a warm soap and water
solution then dry thoroughly prior to use.
The Manufacturer does not recommend the sterilization of this equipment.
Carrying Bag
To clean the carrying bag and strap, brush only with warm soapy water (do not saturate the bag), then allow to air dry. Do not
machine wash or dry the bag.
FreeStyle 5 Accessories