AirSep MN166-1 B - Manual (Page 11)

7 MN166-1 rev B
Properly secure, belt or otherwise restrain the oxygen concentrator when in a vehicle during transport to prevent damage or
injury.
If the oxygen concentrator has been dropped, damaged, or exposed to water, please contact your home care provider for
inspection or possible repair of the device. Do not use the oxygen concentrator if it has a damaged power cord or plug.
Cet appareil produit de l’oxygène à concentration élevée, favorisant une combustion rapide. Ne pas permettre de fumer ou
des flammes nues dans la même chambre: (1) cet appareil ou (2) tout accessoire contenant de l’oxygène. Ne pas utiliser de
produits à base d’huile, de graisse ou de pétrole sur ou à proximité de l’unité. Déconnecter le cordon d’alimentation de la
prise électrique avant de nettoyer ou de faire l’entretien de l’unité.
Risque de choc électrique. Ne pas enlever les couvercles lorsque l’unité est branchée. Seuls votre fournisseur d’équipement
ou un technicien de service qualifié devrait enlever les couvercles ou faire l’entretien de l’unité.
Federal (USA) law restricts this device to sale or rental by order of a physician or other licensed health care provider.
Do not position the Concentrator so that it is difficult to access the power cord.
The concentrator should be located as to avoid smoke, pollutants or fumes.
Always place oxygen supply tubing and power cords in a manner that prevents a trip hazard.
Do not operate unit in a restricted or confined space (i.e., a small case or handbag) where ventilation can be limited. This can
cause the Oxygen Concentrator to overheat and impair performance.
Do not allow either the air intake or the air outlet vents to become blocked. DO NOT drop or insert any objects into any
openings on the device. This can cause the Oxygen Concentrator to overheat and impair performance.
When using the Oxygen Concentrator in an automobile, boat, or on other DC sources with the DC power supply, make sure
that the vehicle is started and running before connecting the Oxygen Concentrator. If the DC power supply does not
illuminate and requires resetting, disconnect the DC power supply from the DC outlet, restart your vehicle, and then
reconnect your DC power supply into the DC outlet. Failure to follow these instructions can result in the power supply not
supplying power to the Oxygen Concentrator.
When the automobile in which you are using the Oxygen Concentrator unit is turned off, disconnect and remove the device
from the automobile. Do not store the Oxygen Concentrator in a very hot or cold automobile or in other similar, high-or low-
temperature environments.
DO NOT leave the Oxygen Concentrator or the Power Supply plugged into the vehicle if the ignition is in the OFF position.
Doing so may drain the vehicle’s battery.