Brewer AssistPRO - Manual (Page 9)

Document # 101522 0608 REV A ER 784 9
WARNING
Keep personnel and equipment clear of table be-
fore initiating movement to avoid personal injury
or damage to the equipment.
CAUTION
The foot control and hand pendant are moisture
resistant and run on low voltage. To avoid tempo-
rary or permanent damage to the controls, do not
immerse in water or liquids.
CAUTION
Keep foreign objects away from controls. To avoid
accidental operation, be sure the controls are NOT
positioned below the legrest or headrest linkage.
Failure to do so could result in unwanted motion
and possible damage to the table.
NOTE: Each control function will automatically stop mov-
ing when either the UP or DOWN travel limit is reached.
If the button is pressed with travel at its limit, the actua-
tor will not run. Sensors prevent the actuator motor from
operating when travel limit has been reached, preventing
wear of the actuator.
Leg
Down
Table
Down
Figure 10
Controls
1. See figure 10 for the pedal and button identifications on
the foot control
2. See figure 11 for the button identifications on the hand
pendant
OPERATION (CONTINUED)
Program Recall
Mode
Stop
Program
Recall #3
Program
Recall #4
Tilt
Down
Back
Down
Program
Recall #2
Program
Recall #1
Program
Set
Leg
Up
Table
Up
Tilt
Up
Back
Up