Warning – Brewer AssistPRO User Manual

Page 8

Document # 101522 0608 REV A ER 784

General

WARNING

If the table malfunctions, immediately remove your

hand or foot from the controls, unplug the power

cord from the electrical receptacle, and assist the

patient from the table. If table continues to mal-

function, call for service. Do not attempt to repair

table yourself.

WARNING

Before initiating power, keep personnel and equip-

ment clear of the table movement to avoid personal

injury or equipment damage.

OPERATION

NOTE: For optimum table performance, allow the table to

reach room temperature before operating.

NOTE: The table is not designed for continuous opera-

tion. If the table is operated continuously causing the

control to exceed its allowable operating temperature, the

table will go into a reduced speed mode. If normal opera-

tion ceases, do not attempt to operate the table. Allow the

table to cool for 10-15 minutes before attempting to use

again.

NOTE: If operation does not resume after a cooling

period of one hour, contact your dealer or an authorized

service center for repair.

Figure 9

Safety On/Off switches

1. The table is equipped with two On/Off switches that dis-

rupt the main power to the table.

2. The switches are located on the upper left and right hand

sides of the backrest shroud. See figure 9.

3. In the “On” position the switch is lighted green.

Both switches must be in the On, lighted position for the

table to operate.