HP 2310mfd 23 inch Diagonal LCD Monitor - Manual (Page 34)

32
LEGAL NOTICES
Regulatory Notices – Federal
Communications Commission Notice
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses, and can radiate radio frequency energy
and, if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in
a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna. •
Increase the separation between the •
equipment and the TV.
Connect the equipment into wall power
•
outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio
•
or television technician for help.
Modifications
The FCC requires the user to be notified that
any changes or modifications made to this device
that are not expressly approved by our company
may void the user’s authority to operate the
equipment.
Cables
Connections to this device must be made with
shielded cables with metallic RF/EMI connector
hoods to maintain compliance with FCC Rules
and Regulations.
Canadian notice
This Class B digital apparatus meets all
requirements of the Canadian Interference-
Causing Equipment Regulations.
Avis Canadian
Cat apparel numerous de la classed B respected
toutes les exigencies du règlement sur le materiel
brouilleur du Canada.
Power Cord Set Requirements
The MFM power supply is provided with
Automatic Line Switching (ALS). This feature
allows the MFM to operate on input voltages
between 100–120V or 200–240V.
The power cord set (flexible cord or wall plug)
received with the MFM meets the requirements
for use in the country where you purchased the
equipment.
If you need to obtain a power cord for a different
country, you should purchase a power cord that is
approved for use in that country.
The power cord must be rated for the product
and for the voltage and current marked on the
product's electrical ratings label. The voltage and
current rating of the cord should be greater
than the voltage and current rating marked on
the product. In addition, the cross-sectional area
of the wire must be a minimum of 0.75 mm² or
18 AWG, and the length of the cord must be
between 6 feet (1.8 m) and 12 feet (3.6 m).If you
have questions about the type of power cord to
use, contact an authorized HP service provider.
A power cord should be routed so that it is not
likely to be walked on or pinched by items placed
uponit or against it. Particular attention should be
paid to the plug, electrical outlet, and the point
where the cord exits from the product.