HP 2310mfd 23 inch Diagonal LCD Monitor - Manual (Page 11)

9
SELECTING A GOOD LOCATION
Please make sure to connect the power plug to
the wall outlet socket after connecting the MFM
to the power cord!
Install the base stand; place the MFM 1.
on a solid surface.
Min
1 m
Ensure that the MFM is placed in a position
to allow free flow of air. Do not cover the
ventilation openings on the back cover.
To prevent any unsafe situations, flame
sources, such as lighted candles, should not
be placed on or in the vicinity.
Avoid heat, direct sunlight and exposure to
rain or water. The equipment should not be
exposed to dripping or splashing water.
Connect the antenna cable or CATV cable 2.
to the aerial socket TV ANTENNA at the
back of the MFM.
Remote control: 3.
Remove the cover of the battery
compartment. Insert the 2 batteries supplied
(Type AAA 1.5V).
Power: 4.
Insert the power cord in the wall socket
with AC power supply. You can see LED
states at the front panel. If the LED colour
is Green, the MFM set power is on. If the
LED colour is Red, the MFM set is in standby
state.
Turn on the MFM: 5.
Press the POWER key on the Remote
control or the side panel control knobs
on the monitor. The MFM will turn on in a
minute with display on the screen.
Power Key