Setting up the mfm, Attaching the base, Preparing the mfm for wallmounting – HP 2310mfd 23 inch Diagonal LCD Monitor User Manual
Page 10: Preparing the mfm for wall mounting
8
SETTING UP THE MFM
IMPORTANT: Do not apply pressure to the
screen display area, which may compromise
the integrity of the display. The manufacturer’s
warranty does not cover user abuse or improper
installation.
ATTACHING THE BASE
IMPORTANT: The Base of the MFM must be
assembled prior to usage.
Place MFM unit face down on a soft and flat
1.
surface (blanket, foam, cloth, etc.) to prevent
any damage to the MFM
Carefully align and insert the Base to the
2.
stand.
Gently push the Base towards the MFM until
3.
the locking mechanism locks into place.
ATV Interface
DTV Interface
PREPARING THE MFM FOR WALL
MOUNTING
Place the MFM at least 2.36 inches (60 mm) from
the wall to prevent cable interference.
Before mounting your MFM on the wall, you need
to remove the base.
For your safety, please use listed wall mount
bracket with minimum weight of the MFM without
stand. (
page 26.)
To prepare the MFM to attach a wall mount
bracket (sold separately):
Loosen the screws holding your MFM to the
1.
stand and remove the stand base from the
MFM.
Secure the third party wall mount bracket
2.
to the back of your MFM using four screws,
as indicated in the illustration.
ATV Interface
100 mm
100 mm
M4 screws
DTV Interface
100 mm
100 mm
M4 screws
NOTE
Wall mount bracket & screws are not
•
included